Colltex
11 products
Overall rating | (11 reviews) |
Use the Colltex “hotmelt adhesive” from the tube for partial or complete renewal of the hotmelt adhesive layer. Apply it at room temperature. Fix the ski skin to a table and clean it as well as possible. The best way to do so is with a soldering iron with spatula. Press the hotmelt adhesive directly from the tube onto the ski skin and distribute it regularly over the entire adhesive layer using a spatula.
Tip: distribution is best achieved with a roller. Allow the adhesive to dry for at least 6-8 hours. Protect the new hotmelt adhesive layer with protective netting and stow the ski skin in the bag intended for this purpose.
NOTE! This clue is NOT suitable for Colltex CT40 skins! There is a special glue for CT40 skins.
Overall rating | ☆☆☆☆☆ |
Overall rating |
Very strong smell, I do not recommend to use indoors. Even on the first landing trip, the glue still smelled a lot in the room when the skins were drying. The glue was really hard to spread when I applied with a spatula. According to the instructions, the application should be done with a small rag, which I didn't happen to have. A total of two tubes of glue went into the split skins. The glue worked well on the mountains, the skins stayed attached, and there were no residues left on the bottom.