Savotta Griffin Sling MOD

Installation
As this is a simple two-point sling you don’t need to play around with numerous ends of webbing, just two. The 25 mm / 1 ” webbing fits most sling swivels and mounting hardware out there. With it’s non-fixed padding the Griffin Sling MOD is a little bit different to install than the sewn-on padded MW and HW, you do not need to cut or tape any excess webbing as you can tuck it into the pad.

1. Open up the rear webbing loop by threading the webbing end out through the steel tri-glide buckle. Loop the webbing through the sling swivel, buckle, stock or what ever attachment point you are using on the rear of your firearm. Rethread the webbing through the buckle and do a U-turn to lock it into place.
2. Open up the front quick adjustment webbing loop and remove the steel tri-glide from the webbing. Loop the webbing trough your front sling swivel or buckle, reattach the steel tri-glide and loop the webbing around the rapid adjustment slider and back through the steel tri-glide.
3. Try playing around with different adjustment lengths to the front and rear. When you’ve found the suitable setting you can move all excess webbing to the rear of the sling and tuck it into the padding (it is recommended to use a cleaning rod, long screwdriver or similar impliment to help you out). No need to cut and burn anything!