Apeks XTX50 Sidemount Set

The Apeks DST first stage is a fully balanced diaphragm design with environmental seal to improved cold water protection. The standard four low pressure and been upgraded with the fifth port upgrade to allow for optimal hose routing of the inflator hoses to either drysuit and/or buoyancy device. The swivelling low pressure turret is also ideal, allowing for the best possible positioning of the regulator hoses.

The Apeks XTX50 second stage provides excellent performance, even in the harshest of conditions thanks to carefully engineering. A heat sink at the hose coupling point helps to raise the temperature of the air flow, reducing the risk of the cold air flowing over metal components and causing ice to form. A fully adjustable balanced valve allows for diver customisation and preferences whilst the venturi control helps to prevent accidental free flow when the regulator isn't in use and maximum performance when needed.

Please note that the package in only available in DIN 300 Bar

Included
Two XTX50 DIN regulators with 5 port swivel turrets
One XTX50 has a 83” / 210cm hose
One XTX50 has a 24” / 60cm hose
2 custom length MP inflation hoses, 250mm (10 inches) (one for buoyancy system, one for drysuit)
2 brass pressure gauges with 6 inch hoses (available in metric and imperial)
1 x 90° elbow fitting
1 x bungee necklace
1 x stainless steel clip
2 sets of short exhaust ports
Regulator bag to hold all
Setup illustration, CD manual and quick start guide